Diatomaceous earth liquid powder

cdVet Kieselgur Liquid Powder drying agent

100% natural diatoms, finely ground, sprayable - highly drying spreading agent for use in stables or in the home.

Kieselgur Liquid Powder is characterized by its good water miscibility and thus allows dust-free application. Due to its specific fast drying properties, its effectiveness is fully maintained.

Kieselgur Liquid Powder has the following properties:

• Strong moisture binding
• Binds flea and mite droppings
• Optimized stable hygiene Better stable climate, fewer flies
• High and long-lasting effectiveness
• Purely biophysical effect

Kieselgur Liquid Powder cannot be overdosed. The quantity applied to the required areas depends on the nature of the material. A light-colored coating should be visible everywhere on the treated surfaces.

Diatomaceous earth consists of the ground skeletons of fossil diatoms, the so-called "diatoms". These skeletons consist of silicon oxide. The use of diatomaceous earth as a natural raw material is becoming increasingly important. Its absorptive capacity is useful wherever liquids or Moisture need to be bound.

The product is extremely safe, especially when used in the immediate vicinity of pet food.
However, the product should NOT be FEEDED!

All commercially available pressure-operated hand or backpack sprayers are suitable for application. The sprayers should be thoroughly cleaned with water immediately after use to avoid clogging (if necessary, remove all individual parts of the sprayer and clean separately).

Special product

Composition: naturally extracted microelement earths

Recommendation for use:

Wet application: Mix the powder with water (1/3 powder + 2/3 water) by volume and stir well.

Then apply liberally to the affected areas with a brush, stirring the mixture well again and again.

The mixture can also be nebulized in a spray bottle or garden sprayer (coarse nozzle, e.g. 0.5mm!); e.g. stables or plants can be sprayed directly in this way.

The treated area should be completely covered with a diatomaceous earth film. Depending on requirements, 10 - 20g Kieselguhr Liqiud Powder/m² should be applied.

1 liter mixture is sufficient for approx. 4 - 5m².

Powder residues can be brushed off after application or removed with a vacuum cleaner.

Close packaging tightly after use! Can be stored indefinitely in a dry place!

Attention, light-colored materials can be discolored! Please test on a concealed area before use!